Problem first start

A place for general Nuffield questions and chat
Post Reply
hakiss
Posts: 2
Joined: Sun Nov 29, 2020 10:23 pm
Sweden

Problem first start

Post by hakiss » Thu Jan 07, 2021 8:47 am

Hi
I have change crank in engine 10/60
Timing chain settling some workshop book.
1 cyl top TDC in/out valve closed
Injector pump see picture .
But it running not good , on one cylinder and come fire out .
Have I set set pump 180 degree wrong :?:
How can I see that .

Image

Image



mike.l
Posts: 232
Joined: Fri Mar 30, 2018 10:29 pm
Location: london ontario
Canada

Re: Problem first start

Post by mike.l » Fri Jan 08, 2021 11:55 pm

Hi Nobody answered you so will go with what i know about your problem you are doing it all correct and the only thing i can think is you are 180 degrees out. take the side off the pump and also take the rocker cover off pull the stop out turn the tractor over by hand you will see the injector pump rising to deliver fuel to the next cylinder in the firing order check the valves should be closed on to the next and next you will soon find the cause of it not running. i should add the obvious the injector pump turns at half the revs of the engine Mike

hakiss
Posts: 2
Joined: Sun Nov 29, 2020 10:23 pm
Sweden

Re: Problem first start

Post by hakiss » Sat Jan 09, 2021 2:53 pm

Thanks now its work fine again :P

Post Reply